When running VMware vSphere 6 or vSphere 7 and ESXi on your hosts with VMFS6, you may notice that auto unmap (space reclamation) is not working even though it is enabled. In addition, you’ll find that manual unmap functions still work.
This is because your storage array (SAN) may have a larger unmap granularity block size than 1MB. VMFS version 6 (source) requires an unmap granularity of 1MB and does not support automatic unmap on arrays that are larger.
For example, on the HPE MSA 2040 the page size when using virtual storage is 4MB, hence auto unmap is not supported and does not work. You can still manually perform unmap on arrays with block/page sizes larger than 1MB.
Perform manual VMFS unmap on vSphere 6.5 and 6.7 with VMFS 6 – https://www.stephenwagner.com/2017/02/07/vmfs-unmap-command-vsphere-6-5-with-vmfs-6-auto/
vSphere 6.5, 6.7 and VMFS 6 – Change storage reclaim priority from low to medium or high – https://www.stephenwagner.com/2017/02/08/vsphere-vmfs-6-change-storage-reclaim-priority-low-medium-high/
Release unused space on host and guest filesystems with thin-provisioned Sophos UTM appliance (SW) – https://www.stephenwagner.com/2018/01/18/release-unused-space-vmdk-thin-provisioned-sophos-utm/
While most of us frequently deploy new ESXi hosts, a question and task not oftenly discussed is how to properly decommission a VMware ESXi host. Some might be surprised to… Read More
This guide will outline the instructions to Disable the VMware Horizon Session Bar. These instructions can be used to disable the Horizon Session Bar (also known as the Horizon Client… Read More
Normally, any VMs that are NVIDIA vGPU enabled have to be manually migrated with manual vMotion if a host is placed in to maintenance mode, to evacuate the host. While… Read More
You may experience GPU issues with the VMware Horizon Indirect Display Driver in your environment when using 3rd party applications which incorrectly utilize the incorrect display adapter. This results with… Read More
Today we're going to cover a powerful little NAS being used with VMware; the Synology DS923+ VMware vSphere Use case and Configuration. This little (but powerful) NAS is perfect for… Read More
Today we'll go over how to install the vSphere vCenter Root Certificate on your client system. Certificates are designed to verify the identity of the systems, software, and/or resources we… Read More
View Comments
In vsphere 7.0 the Reclaim Granularicty is configurable ,
[root@vmhtst999:~] esxcli storage vmfs reclaim config get -l san99_vol42
Reclaim Granularity: 1048576 Bytes
Reclaim Priority: high
Reclaim Method: fixed
Reclaim Bandwidth: 100 MB/s
So 4MB should be 4,194,304 , I will check on my Storage which "BlockSize" we use and give it a try .
esxcli storage vmfs reclaim config set -l san99_vol42 --reclaim-granularity 4194304 --reclaim-method fixed --reclaim-priority high -b 100